MX2020 3D Universal Edge Router Hardware Guide
Installing an MX2020 Adapter Card
248
An ADC weighs up to 15 lb (6.80 kg). Be prepared to accept its full weight.
To install an ADC (see
Figure 108 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the ADC from its electrostatic bag.
2.
Identify the slot on the router where it will be installed.
3.
Orient the ADC so that the faceplate faces you vertically.
4.
Lift the ADC into place, and carefully align the sides of the ADC with the guides inside
5.
the card cage.
Slide the ADC all the way into the card cage until you feel resistance.
6.
Grasp both ejector handles, and gently close them inward simultaneously until the
7.
ADC is fully seated.
Issue the following CLI command to bring the ADC online:
8.
user@host>request chassis adc slot slot-number online
For more information about the command, see the
.
Command Reference
NOTE:
When issuing the
will gain power, and the system total power will decrease.
249):
Junos OS System Basics and Services
request chassis adc online
Copyright © 2013, Juniper Networks, Inc.
command, the FRU