Installing The Mx2010 Router Using A Pallet Jack With Attachment - Juniper MX2010 Hardware Manual

Figure 96: Installing Pallet Jack Attachment onto Pallet Jack
RELATED DOCUMENTATION
Preparing the Site for the MX2008 Router Overview

Installing the MX2010 Router Using a Pallet Jack with Attachment

Before installing the router, you must remove all components (see
MX2010 Router Chassis Before Installing It in a Rack" on page
To install the router by using a pallet jack with attachment:
1. Ensure that the rack is in its permanent location and is secured to the building. Ensure that the installation
site allows adequate clearance for both airflow and maintenance. See
Airflow and Hardware Maintenance for the MX2010 Router" on page
2. Reattach the front and rear shipping covers to the chassis to help move the router. The handles on the
shipping covers are used to guide the chassis during installation.
"Removing Components from the
239).
"Clearance Requirements for
147.
253