Figure 240: Reattaching the Sheet Metal Cover and EMI Door
1
2
7. Reattach any external devices connected to the craft interface.
SEE ALSO
MX2010 Craft Interface Description | 29
Maintaining and Verifying the Status of the MX2010 Craft Interface | 684
Connecting the Alarm Relay Wires to the MX2010 Craft Interface
Here's how to connect the alarm relay wires between a router and an alarm-reporting device (see
Figure 148 on page
346):
1. Prepare the required length of replacement wire with gauge between 28 AWG (0.08 mm
2
(2.08 mm
).
2. Insert the replacement wires into the slots in the front of the block (see
2.5-mm flat-blade screwdriver to tighten the screws and secure the wire.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2
) and 14 AWG
Table 90 on page
347). Use a
474