Connecting Ac Power To An Mx2000 Router With Three-Phase Wye Ac Power Distribution Modules - Juniper MX2010 Hardware Manual

14. Screw the retaining nut onto the AC power cord to secure it to the metal wiring compartment.
15. Reinstall the metal PDM wiring cover, and using a number 2 Phillips (+) screwdriver, tighten the four
captive screws on the metal AC wiring compartment.
16. Use the provided plastic cable tie to fasten the AC power cord to the PDM.
17. Verify that the AC power cord does not touch or block access to router components, and that it does
not drape where people could trip on it.
18. Repeat the procedure for the other three-phase delta AC PDMs.
RELATED DOCUMENTATION
MX2000 Three-Phase Delta AC Power Distribution Module Description | 100
MX2000 Three-Phase Delta and Wye AC Power Distribution Module LEDs | 107
Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2000
Routers | 185
Powering On a Three-Phase AC-Powered MX2000 Router | 319
MX2000 AC Power System Electrical Specifications | 173
MX2000 AC Power Cord Specifications | 170
Prevention of Electrostatic Discharge Damage | 794
Connecting AC Power to an MX2000 Router with Three-Phase Wye AC
Power Distribution Modules
CAUTION:
same router.
WARNING:
Do not mix AC and DC power distribution modules (PDMs) within the
Power connections must be performed by a licensed electrician only.
295