Installing The Mx2010 Standard Emi Cover - Juniper MX2010 Hardware Manual

Figure 260: Removing the EMI Card-Cage Cover
SEE ALSO

Installing the MX2010 Standard EMI Cover | 382

Preventing Electrostatic Discharge Damage to an MX Series Router
Installing the MX2010 Standard EMI Cover
The MPCs require an EMI cover to reduce the risk of radio frequency interference disturbance that affects
an electrical circuit because of electromagnetic interference emitted from an external source. The EMI
cover is designed to reduce the electromagnetic interference (EMI) to comply with the Federal
Communications Commission (FCC) requirements.
To install the EMI card-cage cover (see
1. Align the four brackets on either side of the EMI cover with the chassis front-mounting flanges on the
outside of the card cage.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Adjust the EMI cover until the four captive screws align with the holes in the front-mounting flanges.
Figure 173 on page 383):
503