Ac Power Requirements, Specifications, And Guidelines; Mx2010 Ac Power Requirements - Juniper MX2010 Hardware Manual

CHAPTER 12
AC Power Requirements, Specifications, and
Guidelines
IN THIS CHAPTER

MX2010 AC Power Requirements | 161

MX2000 AC Power Cord Specifications | 170
MX2000 AC Power System Electrical Specifications | 173
MX2000 Router Grounding Specifications | 175
MX2000 Three-Phase Delta AC Power Distribution Module Electrical Specifications | 178
MX2000 Three-Phase Wye AC Power Distribution Module Electrical Specifications | 179
MX2000 Single-Phase AC Power Distribution Module Electrical Specifications | 180
Calculating AC Power Requirements for MX2010 Routers | 180
Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2000
Routers | 185
MX2010 AC Power Requirements
To allow for future growth so that you can operate the router in any hardware configuration without
upgrading the power infrastructure, we recommend that you provision 2800 W for each AC power
distribution module (PDM) (three-phase or single-phase).
If you do not plan to provision 2800 W for each AC power supply module, use the information in
Table 51 on page 162 and
configurations, input current from a different source voltage, and thermal output.
Table 53 on page 163 lists the power requirements for various hardware components when the router is
operating under typical voltage conditions.
NOTE: Unlike all the other MPCs, MPC6E, MPC8E, and MPC9E do not require an adapter card
(ADC) to house the MPC in the MX2010 router.
Table 52 on page 162 to calculate power consumption for various hardware
161