Mx2010 Modular Interface Card Leds; Mx2010 Port And Interface Numbering - Juniper MX2010 Hardware Manual

MX2010 Modular Interface Card LEDs

Each MIC has LEDs located on the faceplate. For more information about LEDs on the MIC faceplate, see
the "LEDs" section for each MIC in the
RELATED DOCUMENTATION
Maintaining MX2010 MICs | 651
Troubleshooting the MX2010 MICs | 725
Replacing an MX2010 MIC | 515

MX2010 Port and Interface Numbering

In the physical part of the interface name, a hyphen (-) separates the media type from the MPC number
(represented as an FPC in the CLI), and a slash (/) separates the logical PIC and port numbers:
type-fpc/pic/port
type—Media type, which identifies the network device. For example:
ge—Gigabit Ethernet interface
so—SONET/SDH interface
xe—10-Gigabit Ethernet interface
For a complete list of media types, see Interface Naming Overview.
fpc—Slot in which the MPC is installed. On the MX2010 router, the MPCs are represented in the CLI as
FPC 0 through FPC 9.
pic—Logical PIC on the MIC. The number of logical PICs varies depending on the type of MIC.
port—Port number.
NOTE: The MIC number is not included in the interface name.
The MX2010 supports up to ten MPCs that install vertically and are numbered from left to right.
The following sample CLI output displays an MPC (MPCE Type 2 3D) installed in MPC slot 9.
user@host> show chassis hardware
MX Series Interface Module Reference.
90