Maintaining The Mx2010 Control Boards - Juniper MX2010 Hardware Manual

On a regular basis:
Check the status of the MX2010 chassis FRU power on-sequence by issuing the
show chassis power sequence command.
The following output displays the chassis FRU power-on sequence:
user@host> show chassis power sequence
Chassis FRU Power On Sequence: 0 1 2 3 4 5 6 7 8 9
NOTE: Because the MPCs are combined with the adapter cards, the MPCs might not boot
up in a specific power-on sequence.
RELATED DOCUMENTATION
MX2010 Power System Description | 95
Troubleshooting the MX2000 Router Power System | 320
Maintaining the MX2010 Power Usage | 672
Preventing Electrostatic Discharge Damage to an MX Series Router
Troubleshooting the MX2000 Router Power System | 320

Maintaining the MX2010 Control Boards

Purpose
For optimum router performance, verify the condition of the Control Board and Routing Engine (CB-RE).
Action
On a regular basis:
Check the host subsystem LEDs on the craft interface. For more information about the LEDs and the
display, see "MX2010 Craft Interface Description" on page 29
During normal operations:
The green host subsystem ONLINE LED on the craft interface is lit.
The red host subsystem OFFLINE LED on the craft interface is not lit.
Check the LEDs on the Control Board portion of the CB-RE faceplate.
.
611