Remx2K-X8-128G Cb-Re Boot Sequence - Juniper MX2010 Hardware Manual

Table 20: REMX2K-X8-128G CB-RE LEDs (continued)
Label Color
DISK1 and Green
DISK2
-
BITS, GPS, Green
and UTI LEDs
OK/FAIL Green
Yellow
MASTER Blue

REMX2K-X8-128G CB-RE Boot Sequence

The router is shipped with Junos OS and Linux preinstalled on the CB-RE. There are two copies of software:
One copy on a USB flash drive that can be inserted into the slot on the CB-RE faceplate.
One copy each on the two SSDs in the CB-RE.
NOTE: The SSD is internal and cannot be removed.
The Routing Engine interface boots from the storage media in this order: the USB device, SSD1, SSD2,
and then the LAN.
RELATED DOCUMENTATION
Supported Routing Engines by Router
Routing Engine Specifications
State Description
Blinking Indicates presence of disk activity.
Off There is no disk activity.
Blinking A valid signal is detected on the BITS, GPS or UTI ports.
Off The link is down due to loss of signal (LOS). Check the cable
and verify the external clock source is generating a valid
signal.
On steadily Routing Engine is powering up.
On steadily Routing Engine is not powering up, which indicates failure.
On steadily This Routing Engine is the Master Routing Engine.
61