Reinstalling The Power Supply Modules - Juniper MX2010 Hardware Manual

Figure 115: Reinstalling a DC Power Distribution Module (240 V China)
NOTE: For the DC-powered router, make sure the switch is set to 60 A, or 80 A to match the
DC circuit input feed. This does not apply to the 240 V China DC PDM.

Reinstalling the Power Supply Modules

To reinstall the AC or DC PSMs, follow this procedure for each PSM (see
Figure 117 on page 280).
1. Remove the PSM to be installed out of the ESD bag, and identify the slot where it will be installed; 0
through 8.
NOTE: The MX2010 PSMs can be installed in any order in the chassis.
2. For an AC-powered router, move the AC power switch on the PSMs to the off (O) position. For a
DC-powered router, move the DC power switch on the PSMs to the off (O) position.
Figure 116 on page 280
279
and