Ex9200-12Qs Line Card; Line Card Models; Table 29: Ex9200-12Qs Line Card; Installing A Line Card In An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide

EX9200-12QS Line Card

Line Card Models

66
Installing a Line Card in an EX9200 Switch on page 220
Installing a MIC in an EX9200-MPC Line Card on page 225
Handling and Storing Line Cards in EX9200 Switches on page 215
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.

This topic describes:

Line Card Models on page 66
Line Card Components on page 67
Table 29 on page 66 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.

Table 29: EX9200-12QS Line Card

Model Description
EX9200-12QS A line card with 12 rate-selectable ports, each
of which can house transceivers. All ports can
operate at 10-Gbps and 40-Gbps speeds. The
ports are configured to operate at 10-Gbps
speed by default. The ports labeled
, and
1/2
operate at 100-Gbps speed also. The line card
supports maximum transmission units (MTUs)
from 256 bytes through 9192 bytes.
NOTE: For the EX9200-12QS line card to be operational, you must install the EX9200-SF2 Switch
Fabric module (SF module) in the switch. See
page 33 and "Installing an SF Module in an EX9200 Switch" on page
Figure 31 on page 67 shows the components of an EX9200-12QS line card.
0/2
(see Figure 31 on page 67) can
1/5
"Switch Fabric Module in an EX9200 Switch" on
Copyright © 2017, Juniper Networks, Inc.
Junos OS Release
Required
16.1R1 or later
, ,
0/5
209.