Connecting An Mx2000 Router To A Console Or Auxiliary Device - Juniper MX2010 Hardware Manual

2. Plug one end of the Ethernet cable
on the CB-RE interface.
Ethernet ports.
3. Plug the other end of the cable into the network device.
Figure 138: Out-of-Band Management Port
1 2 3
Figure 139: Out-of-Band Management Cable Connector
Table 84: Out-of-Band Management Port on the MX2010 CB-RE
Function No.
3
SEE ALSO
Connecting the MX2010 Router to Management and Alarm Devices | 337

Connecting an MX2000 Router to a Console or Auxiliary Device

To use a system console to configure and manage the Routing Engine, connect it to the appropriate
CONSOLE port on the RCB interface. To use a laptop, modem, or other auxiliary device, connect it to the
AUX port on the RCB interface. Both ports accept a cable with an RJ-45 connector. One serial cable with
an RJ-45 connector and a DB-9 connector is provided with the router. To connect a device to the CONSOLE
port and another device to the AUX port, you must supply an additional cable.
(Figure 139 on page 338
Figure 138 on page 338
Label
MGMT
shows the connector) into the MGMT port
shows the port. Table 84 on page 338
Description
Dedicated management channel for device
maintenance. It is also used by system
administrators to monitor and manage the
MX2010 remotely.
338
describes the