Installing A Cable On An Mx2010 Mpc Or Mic - Juniper MX2010 Hardware Manual

Press the online/offline button on the MIC. Use a narrow-ended tool that fits inside the opening
that leads to the button. Press and hold the button until the MIC LED goes off (about 5 seconds).
Issue the following CLI command:
user@host> request chassis mic fpc-slot fpc-slot mic-slot mic-slot offline
For more information about the command, see the
Reference.
3. Unplug the cable from the cable connector port. If the MIC uses fiber-optic cable, immediately cover
each transceiver and the end of each cable with a rubber safety cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager, and detach it from the destination port.
SEE ALSO

Installing a Cable on an MX2010 MPC or MIC | 445

Preventing Electrostatic Discharge Damage to an MX Series Router
Installing a Cable on an MX2010 MPC or MIC
To install a MIC cable or an MPC cable (see
1. Have ready a length of the type of cable used by the component. For cable specifications, see the
Series Interface Module
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when
Figure 212 on page 446
Reference.
Junos OS System Basics and Services Command
and Figure 213 on page
445
447):
MX