Installing An Sfp Or Xfp Into An Mx2000 Mpc Or Mic - Juniper MX2010 Hardware Manual

13. Flip the power switch on all the PSMs to the on (|) position to provide power to the router components.
14. Verify that the LEDs on the PDM faceplate are lit steadily green, indicating that the AC terminal block
is receiving power.
15. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
RELATED DOCUMENTATION
MX2000 Seven-Feed Single-Phase AC Power Distribution Module Description | 105
MX2000 Nine-Feed Single-Phase AC Power Distribution Module Description | 106
MX2000 Single-Phase AC Power Distribution Module Electrical Specifications | 180
Troubleshooting the MX2000 Router Power System | 320
Removing an MX2000 Single-Phase AC Power Distribution Module

Installing an SFP or XFP into an MX2000 MPC or MIC

To install an SFP or XFP:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each transceiver to be installed out of its electrostatic bag, and identify the slot on the component
where it will be installed.
3. Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a
safety cap.
4. Carefully align the transceiver with the slots in the component. The connectors should face the
component.
5. Slide the transceiver until the connector is seated in the component slot. If you are unable to fully insert
the transceiver, make sure the connector is facing the right way.
6. Close the ejector handle of the transceiver.
427