457
Figure 222: Installing the PSM Air Filter
D
To remove the PSM air filter—MX2000-FLTR-PWR for a chassis with the DC PDM (240 V China) installed:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the screws from the mechanical interlock bracket to remove it. See
Figure 157 on page
364.
Figure 223: Removing the bracket from the PDM
CAUTION: REINSTALL INTERLOCK BRACKET
AFTER PSM AIR FILTER SERVICE
3. Loosen the two captive screws located on either side of the air filter and pull slightly out of the chassis.