Mx2010 Component Leds On The Craft Interface; Mx2010 Host Subsystem Leds And Buttons On The Craft Interface - Juniper MX2010 Hardware Manual

Table 10: Craft Interface LEDs, Buttons, and Connectors (continued)
Function No.
10
11
RELATED DOCUMENTATION
Replacing the MX2010 Craft Interface | 468
MX2010 Craft Interface Serial Number Label | 741

MX2010 Component LEDs on the Craft Interface

IN THIS SECTION

MX2010 Host Subsystem LEDs and Buttons on the Craft Interface | 31

MX2010 Power Supply Module LEDs on the Craft Interface | 32
MX2010 Line-Card LEDs and Buttons on the Craft Interface | 32
MX2010 SFB LED and Buttons on the Craft Interface | 33
MX2010 Fan Tray LEDs on the Craft Interface | 34
MX2010 Host Subsystem LEDs and Buttons on the Craft Interface
Each host subsystem has three LEDs, located in the upper middle of the craft interface, that indicate its
status. The LEDs labeled RE0 show the status of the Routing Engine on the CB-RE in slot 0. The LEDs
Label
LC 0 through LC 9
SFB 0 through SFB 7
Description
Online and Offline buttons located next to each
line card enable you to take individual line cards
offline or online.
Status LEDs for the lower ten line cards.
Online and Offline buttons located next to each
SFB enable you to take individual SFBs offline
or online.
Status LEDs for eight SFBs.
31