Mx2000 Ac Power Cord Specifications - Juniper MX2010 Hardware Manual

Table 53: MX2010 FRU AC Power Requirements (continued)
Component
Tri-Rate MIC
MIC MRATE
DS3/E3 MIC
Channelized OC3/STM1
(Multi-Rate) Circuit Emulation
MIC with SFP
RELATED DOCUMENTATION
MX2010 Power System Description | 95
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution
Modules | 291
Connecting AC Power to an MX2000 Router with Three-Phase Wye AC Power Distribution
Modules | 295
Connecting Power to an MX2000 Single-Phase AC Power Distribution Module | 300

MX2000 AC Power Cord Specifications | 170

MX2000 AC Power Cord Specifications
Most sites distribute power through a main conduit that leads to frame-mounted power distribution panels,
one of which can be located next to the rack that houses the router. An AC power cord connects each
power distribution module (PDM) to the power distribution panel. Detachable AC power cords are supplied
with the router. For single–phase PDMs, the coupler type is C21. For three-phase power, the power cord
wires are inserted into the AC input terminal with the help of a screwdriver. The plug end of the power
cord fits into the power source receptacle for your geographical location.
Model Number
MIC-3D-40GE-TX
MIC-MRATE
MIC-3D-8DS3-E3
MIC-3D-8CHDS3-E3-B
MIC-3D-4COC3-1COC12-CE
Maximum Power Requirement
41 W
When installed into MPC8E:
1.250 A @ 48 V (60 W)
When installed into MPC9E:
1.771 A @ 48 V (85 W)
36 W at 55° C
35 W at 40° C
34 W at 25° C
33.96 W
170