Packing The Mx2010 Router For Shipment - Juniper MX2010 Hardware Manual

Packing the MX2010 Router for Shipment

To pack the router for shipment:
1. Retrieve the shipping crate and packing materials in which the router was originally shipped. If you do
not have these materials, contact your Juniper Networks representative about approved packaging
materials.
2. On the console or other management device connected to the master CB-RE, enter CLI operational
mode and issue the following command to shut down the router software. (If two CB-REs are installed,
also issue the command on the backup CB-RE.)
user@host> request system halt
Wait until a message appears on the console confirming that the operating system has halted.
For more information about the command, see the
Reference.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
4. Shut down power to the router by switching the AC or DC circuit breaker for all PDMs to the off (O)
position.
5. Disconnect power from the router.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the router.
8. Attach the front and rear shipping covers.
CAUTION:
covers can damage the chassis.
Junos OS System Basics and Services Command
Apply force to any other parts of chassis other than the shipping
694