Installing The Mx2010 Extended Emi Cover - Juniper MX2010 Hardware Manual

Figure 173: Installing the EMI Card-Cage Cover
RELATED DOCUMENTATION
Removing the MX2010 Standard EMI Cover | 502
Preventing Electrostatic Discharge Damage to an MX Series Router

Installing the MX2010 Extended EMI Cover

The extended electromagnetic interference (EMI) covers attaches to the router over the card cage.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. On each side of the card cage, orient the extended EMI cover's mounting brackets so that they line up
with the mounting holes. The groove that holds the points on the cover should be at the top.
3. Using a number 2 Phillips (+) screwdriver, secure the extended EMI cover mounting brackets to the
sides of the card cage by using the four screws provided (two on each side) (see Figure 174 on page 384).
383