Replacing The Mx2010 Air Baffle - Juniper MX2010 Hardware Manual

Replacing the MX2010 Air Baffle

Removing the MX2010 Air Baffle | 513
1.
Installing the MX2010 Air Baffle | 514
2.
Removing the MX2010 Air Baffle
To remove the upper air baffle—MX2000-UPR-BAFFLE-A:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the four captive screws located on either side of the air baffle that is attached to the upper fan
tray access door.
3. Grasp the air baffle, and pull straight out from the upper fan tray access door as shown in
Figure 270 on page 513.
Figure 270: Removing the Air Baffle
SEE ALSO
Maintaining the MX2010 Air Baffle | 614
Installing the MX2010 Air Baffle | 387
513