Power System; Mx2010 Power System Description - Juniper MX2010 Hardware Manual

CHAPTER 8

Power System

IN THIS CHAPTER

MX2010 Power System Description | 95

MX2010 Power Midplane Description | 100
MX2000 Three-Phase Delta AC Power Distribution Module Description | 100
MX2000 Three-Phase Wye AC Power Distribution Module Description | 102
MX2000 Seven-Feed Single-Phase AC Power Distribution Module Description | 105
MX2000 Nine-Feed Single-Phase AC Power Distribution Module Description | 106
MX2000 Three-Phase Delta and Wye AC Power Distribution Module LEDs | 107
MX2000 AC Power Supply Module Description | 107
MX2010 AC Power Supply Module LEDs | 110
MX2010 DC Power Distribution Module (-48 V) Description | 111
MX2000 DC Power Distribution Module (240 V China) Description | 113
MX2010 DC Power Distribution Module (-48 V) LEDs | 114
MX2000 DC Power Distribution Module (240 V China) LEDs | 115
MX2010 DC Power Supply Module (-48 V) Description | 116
MX2000 DC Power Supply Module (240 V China) Description | 118
MX2010 DC Power Supply Module LEDs | 121
MX2010 Power System Description
The MX2000 routers are available in -48 V and 240 V China DC power configurations, three-phase (delta
and wye) AC power configurations, and a single-phase power configuration. You can add additional power
to the rack as needed. The MX2010 router is configurable with up to two AC or DC power distribution
modules (PDMs), and up to nine AC or DC power supply modules (PSMs). The PSMs connect to the top
and bottom power backplanes that distribute the output voltages produced by the PSMs to the router
components. Table 30 on page 96
describes the MX2010 AC power components.
describes the MX2010 DC power components and Table 31 on page 97
95