Installing An Mx2010 Mpc Into An Adapter Card - Juniper MX2010 Hardware Manual

Figure 278: Installing an Adapter Card
SEE ALSO
MX2000 Adapter Card (ADC) Description | 69
Maintaining the MX2010 Adapter Cards | 606
Removing an MX2010 Adapter Card | 530

Installing an MX2010 MPC into an Adapter Card

An MPC weighs up to 25 lb (11.34 kg). Be prepared to accept its full weight.
To install an MPC (see Figure 279 on page
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the MPC from its electrostatic bag.
3. Identify the slot on the router where it will be installed.
4. Verify that each fiber-optic transceiver is covered with a rubber safety cap.
5. Orient the MPC so that the faceplate faces you vertically.
535):
533