Replacing A Cable On An Mx2010 Mpc Or Mic; Removing A Cable On An Mx2010 Mpc Or Mic - Juniper MX2010 Hardware Manual

Universal routing platform

Hide thumbs Also See for MX2010:

Table of Contents

Replacing a Cable on an MX2010 MPC or MIC

Installing a Cable on an MX2010 MPC or MIC | 445

Removing a Cable on an MX2010 MPC or MIC

Removing and installing cables on an MPC or a MIC does not affect router function, except that the

component does not receive or transmit data while its cable is disconnected.

To remove a fiber-optic cable:

1. If the component connects to fiber-optic cable, have ready a rubber safety cap for each cable and

transceiver.

2. If you are removing all cables connected to the component, use one of the following methods to take

the component offline:

To take an MPC offline:

Press and hold the corresponding online button on the craft interface. The green OK LED next to

the button begins to blink. Hold the button down until the LED goes off.

Issue the following CLI command:

user@host>request chassis fpc slot slot-number offline

For more information about the command, see the

the FRU loses power, and the system's total power increases.

To take a MIC offline:

When you issue the request chassis fpc slot slot-number offline command,

Junos OS System Basics and Services Command

Show Quick Links

Table of Contents