Installing An Mx2010 Dual-Wide Mic - Juniper MX2010 Hardware Manual

Figure 274: Installing a MIC
SEE ALSO
Maintaining MX2010 MICs | 651
Removing an MX2010 MIC | 515

Installing an MX2010 Dual-Wide MIC | 380

Installing an MX2010 Dual-Wide MIC
To install a dual-wide MIC:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the septum, if necessary (see
a. Place the MPC on a flat surface. If necessary, remove the MPC from the adapter card as described
in "Removing an MX2010 MPC from the Adapter Card" on page
b. Remove the four screws labeled S on the bottom of the MPC.
c. Remove the two screws labeled S on the top of the MPC.
d. Slide the septum toward you and out of the MPC.
Figure 172 on page 380):
528.
520