8. Observe the status LEDs on the PDM faceplate. If the PDM is correctly installed and functioning
normally, the LEDs light green steadily.
9. On each of the DC PSMs, move the switch to the on (|) position.
Replacing the MX2010 Standard EMI Cover
Removing the MX2010 Standard EMI Cover | 502
1.
Installing the MX2010 Standard EMI Cover | 503
2.
Removing the MX2010 Standard EMI Cover
To remove the electromagnetic interference (EMI) card-cage cover (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the four captive screws that secure the EMI cover to the router.
3. Pull the cover away from the router toward you to remove it.
Figure 260 on page
503).
502