Installing The Pallet Jack Attachment - Juniper MX2010 Hardware Manual

3. Install the MX2010. See:
Installing the MX2010 Router Using a Pallet Jack with Attachment on page 253
RELATED DOCUMENTATION
Installing an MX2010 Router Overview | 215
Installing an MX2010 Router Using a Router Transport Kit Overview | 258

Installing the Pallet Jack Attachment

To install the pallet jack attachment to the pallet jack:
1. Remove the pallet jack attachment from the shipping crate.
2. Place the pallet jack attachment across both pallet jack legs.
3. Using a 9/16-in. (14 mm) socket wrench, loosen and remove the eight shipping bracket support torque
fasteners that are located on the top of the pallet jack attachment platform.
4. Using a 9/16-in. (14 mm) socket wrench, loosen the torque fasteners that are located on the four
adjustable pallet jack attachment brackets.
5. Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
6. Tighten the torque fasteners by using a 9/16-in. (14 mm) socket wrench to secure the brackets on the
pallet jack attachment to the pallet jack (see Figure 96 on page 253).
252