Installing The Mx2010 Craft Interface - Juniper MX2010 Hardware Manual

Figure 238: Removing the Craft Interface
SEE ALSO
MX2010 Craft Interface Description | 29
Maintaining and Verifying the Status of the MX2010 Craft Interface | 684

Installing the MX2010 Craft Interface

Here's how to install the MX2010 craft interface:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Grasp the craft interface with one hand, and hold the bottom edge of the craft interface with the other
hand to support its weight.
3. Orient the ribbon cable so that it plugs into the connector socket. The connector is keyed and can be
inserted only one way. The pin on the right side of the craft interface indicates the positioning.
4. Align the pin on the right side of the craft interface with the dedicated hole in the housing and gently
slide the craft interface into the housing. See Figure 160 on page 367.
472