Installing A T320 Pc Card; Figure 85: Removing A Pc Card - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also
212

Figure 85: Removing a PC Card

T320 RE-600 Description on page 34
T320 RE-1600 Description on page 36
Maintaining the T320 Host Subsystem on page 275
Preventing Electrostatic Discharge Damage to a T320 Router on page 330

Installing a T320 PC Card

To install a PC card (see Figure 86 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the Routing Engine cover is in place, remove the cover by loosening the captive
2.
screws on the corners of its faceplate.
Insert the PC card into the PC card slot on the Routing Engine, with the Juniper
3.
Networks logo facing downward.
CAUTION: Be sure to insert the PC card with the label facing downward.
Inserting the PC card incorrectly might damage the Routing Engine.
NOTE: The RE-1600 has two PC Card slots. In this case, use either slot.
Do not install more than one PC card in the Routing Engine.
213):
Copyright © 2018, Juniper Networks, Inc.