Installing The Mx2010 Extended Dc Cable Manager - Juniper MX2010 Hardware Manual

Figure 232: Installing the Extended Lower Cable Manager

Installing the MX2010 Extended DC Cable Manager

To install the extended DC cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the extended DC cable manager over the two slots located on both sides of the DC PDM.
3. Lift the extended DC cable manager slightly up while inserting the two flanges into the slots on both
sides of the DC PDM.
4. Push the extended DC cable manager into place.
5. Tighten the two captive screws to secure the extended DC cable manager.
Figure 181 on page 390):
467