Juniper MX2010 Hardware Manual page 499

4. Tighten the captive screws on the PSM faceplate. Apply between 10 lb-in. (1.13 Nm) to 12 lb-in.
(1.35 Nm) of torque to each screw. Do not overtighten the screws.
5. Turn on the power switch to the on (|) position.
6. Verify that the PWR OK LED is lit steadily green.
Figure 245: Installing a DC Power Supply Module (240 V China)
SEE ALSO
MX2020DC Power Supply Module (-48 V) Description
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX2020 Router
483