Mx2010 Chassis Moving Guidelines - Juniper MX2010 Hardware Manual

Universal routing platform

Hide thumbs Also See for MX2010:

Table of Contents

The minimum front and rear clearance requirements depends on the mounting configuration you choose.

The minimum total clearance inside the cabinet is 36.20 in. (91.95 cm) between the inside of the front

door and the inside of the rear door.

If you are installing the MX2010 router into a network cabinet, make sure that no

hardware, device, rack, or cabinet component obstructs the 34-U rack space from access during

installation.

MX2010 Chassis Moving Guidelines

The fully configured chassis with the cable managers weighs up to 985 lb (446.79 kg), or 324 lb (146.96 kg)

with components removed. Observe the following guidelines for moving the router:

Before moving the router, read the

to verify that the intended site meets the specified power, environmental, and clearance requirements.

Do not attempt to move a fully-configured router by yourself. Use a pallet jack with the attachment and

a four-person team to maneuver the router into a rack.

Before moving the router, disconnect all external cables.

To move routing devices and components, use the following guidelines:

1 person to lift or move up to 39.7 lb (18.0 kg)

2 people to lift or move up to 70.5 lb (32.0 kg)

3 people to lift or move up to 220 lb (99.8 kg)

4 people to lift or move over 300 lb (136.0 kg)

As when moving any heavy object, lift most of the weight with your legs rather than your back. Keep

your knees bent and your back relatively straight and avoid twisting your body as you lift. Balance the

load evenly and be sure that your footing is solid.

"Overview of Preparing the Site for the MX2010 Router" on page 125

Show Quick Links

Table of Contents