Mx2010 Sfb Led And Buttons On The Craft Interface - Juniper MX2010 Hardware Manual

Table 13: Line-Card LEDs on the Craft Interface
Label Color
OK Green
–
FAIL Red
There are ten push buttons located next to each of the line cards on the craft interface. These buttons are
used to place the line cards online or offline. When a line card is inserted into an adapter card, and installed
into the MX2010 router, the online/offline buttons can turn both cards on or off.
NOTE: When installing an adapter card without the line card, the online/offline buttons have
no affect.

MX2010 SFB LED and Buttons on the Craft Interface

Each SFB has one tricolor LED on the craft interface that indicates its status. The SFB LED, labeled 0
through 7, are located along the bottom of the craft interface.
of the SFB LED.
Table 14: SFB LED on the Craft Interface
Label Color
OK Green
–
FAIL Red
State Description
On Line card functioning normally.
steadily
Blinking Line card is transitioning online or offline.
Off The slot is not online.
On Line card has failed.
steadily
State Description
On SFB functioning normally.
steadily
Blinking SFB is transitioning online or offline.
Off The slot is not online.
On SFB has failed.
steadily
Table 14 on page 33 describes the functions
33