Installing An Mx2010 Adapter Card - Juniper MX2010 Hardware Manual

Installing an MX2010 Adapter Card

An adapter card weighs up to 15 lb (6.80 kg). Be prepared to accept its full weight.
To install an adapter card (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the adapter card from its electrostatic bag.
3. Identify the slot on the router where it will be installed.
4. Orient the adapter card so that the faceplate faces you vertically.
5. Lift the adapter card into place, and carefully align the sides of the adapter card with the guides inside
the card cage.
6. Slide the adapter card all the way into the card cage until you feel resistance.
7. Grasp both ejector handles, and gently close them inward simultaneously until the adapter card is fully
seated.
8. Issue the following CLI command to bring the adapter card online:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
Reference.
NOTE: When you issue the request chassis fpc slot slot-number online command, the
FRU gains power, and the system's total power decreases.
Figure 153 on page 361):
Junos OS System Basics and Services Command
360