Juniper MX2010 Hardware Manual page 441

12. Attach the power cord retainer to the PDM to ensure that the AC power cords do not touch or block
access to router components, and that they do not drape where people could trip on them.
Figure 204 on page 425
Figure 204: MX2000 Single-Phase AC Power Cord Retainer
Loosen the two screws at each end of the power cord retainer.
Position the power cord retainer over the PDM power cords with the power cord retainer prongs
facing downward. Refer to
shows the seven-feed and nine-feed power cord retainer.
Figure 205 on page 426.
425