Tools And Parts Required For Replacing Mx2010 Hardware Components - Juniper MX2010 Hardware Manual

Replacing an MX2010 Three-Phase Wye AC Power Cord | 583
Replacing an MX2020 Three-Phase Wye AC Power Distribution Module | 590

Tools and Parts Required for Replacing MX2010 Hardware Components

To replace hardware components, you need the tools and parts listed in
Table 94: Tools and Parts Required for Component Replacement
Components
All
AC power supply module
AC power distribution module
Three-phase delta AC PDM
Three-phase wye AC PDM
AC power cord
Craft interface
Tool or Part
Electrostatic discharge (ESD) grounding wrist strap
Phillips (+) screwdrivers, number 1 and 2
Phillips (+) screwdriver, number 2 to access the metal
AC wiring compartment
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
Phillips (+) screwdrivers, numbers 1 and 2
Table 94 on page 430.
430