Installing The Mx2010 Standard Emi Cover - Juniper MX2010 Hardware Manual

Issue the following CLI command:
user@host> request chassis mic fpc-slot fpc-slot mic-slot mic-slot online
The normal functioning status LED confirms that the MIC is online. You can also verify correct MIC
functioning by issuing the show chassis fpc pic-status command described in
MICs" on page 651.
RELATED DOCUMENTATION
Maintaining MX2010 MICs | 651
Removing an MX2010 MIC | 515
Installing an MX2010 MIC | 390

Installing the MX2010 Standard EMI Cover

The MPCs require an EMI cover to reduce the risk of radio frequency interference disturbance that affects
an electrical circuit because of electromagnetic interference emitted from an external source. The EMI
cover is designed to reduce the electromagnetic interference (EMI) to comply with the Federal
Communications Commission (FCC) requirements.
To install the EMI card-cage cover (see
1. Align the four brackets on either side of the EMI cover with the chassis front-mounting flanges on the
outside of the card cage.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Adjust the EMI cover until the four captive screws align with the holes in the front-mounting flanges.
3. Tighten the four captive screws to secure the EMI cover in place.
Figure 173 on page 383):
"Maintaining MX2010
382