REMOVAL, INSTALLATION AND ADJUSTMENTS
Sterndrive Unit Removal
1. Shift remote control into neutral.
2. Place the drive unit to the full UP/OUT position.
Avoid speedometer hose fitting damage. Disconnect the speedometer hose fitting
from the drive shaft housing before removing the sterndrive unit.
3. Disconnect the speedometer hose fitting from the drive shaft housing.
4. Place the drive unit to the full DOWN/IN position and remove the power trim cylinder
Page 2A-6
from the aft end of the drive shaft housing.
a -
End Cap
b -
Nut
c -
Flat Washer
d -
Bushing
CAUTION
b
d
SERVICE MANUAL NUMBER 28
c
a
90-863160 MAY 2000
22025
22029