Mercury BRAVO Service Manual page 292

BRAVO THREE GEAR HOUSING
4. Apply a light coat of Loctite 242 to inside diameter of thrust cap. Ensure that Loctite does
5. Ensure that all needle bearings are installed in driveshaft needle bearing case. Use
6. Install front driven gear assembly and original thickness shims into gear housing.
Page 3D-30
not contact shim mating surfaces. Install thrust cap and appropriate size shim on outer
propeller shaft. Ensure that cap is straight while pressing into place.
a - Thrust Cap
b - Shim
c - Outer Propeller Shaft
needle bearing assembly lubricant to hold bearings in place.
a - Front Driven Gear Assembly And Shims
b
72212
a
SERVICE MANUAL NUMBER 28
c
a
90-863160 MAY 2000
71799
72261
72249