Install Gear Housing To Drive Shaft Housing - Mercury BRAVO Service Manual

DRIVE SHAFT HOUSING

Install Gear Housing To Drive Shaft Housing

1. Bravo One, Bravo XZ, Bravo XR, and Diesel Bravo One X:
2. Bravo Two and Diesel Bravo Two X:
Page 3A-66
a. Install gear housing to drive shaft housing. Torque nuts and bolt to 35 lb-ft (47 Nm).
a - Nuts and Washers (6)
b - Bolt (Located in Trim Tab Cavity) (1)
b. Install anodic plate. Torque to 20 lb-ft (27 Nm). Install rubber plug.
a
a - Anodic Plate
b - Rubber Plug
a. Install gear housing to drive shaft housing. Torque nuts and bolt to 35 lb-ft (47 Nm).
b
a - Nuts and Washers (6)
b - Bolt (Located in Front of Trim Tab) (1)
a
b
76800
a
SERVICE MANUAL NUMBER 28
76801
b
22093
76802
90-863160 MAY 2000