Exhaust Tube Installation - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
Installation
NOTE: Bellows adhesive is not used when installing an exhaust tube.
Exhaust tube clamp may corrode if grounding clip is not installed.
1. Position grounding clip on exhaust tube as shown.
2. Install exhaust tube on gimbal housing as follows:
90-863160 MAY 2000
a - Exhaust Tube
b - Grounding Clip
a. Position tube so that SIDE markings on tube are facing toward the right and left
sides.
b. Position clamp so that screw will align with screwdriver access hole in port (left) side
of gimbal housing.
c. Tighten clamp. Torque to 35 lb-in. (4 Nm).
a - Exhaust Tube
b - Clamp
c - Side Marking
SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
CAUTION
a
c
b
b
a
22184
22184
Page 4A-31