Mercury BRAVO Service Manual page 133

SERVICE MANUAL NUMBER 28
2. If you determine that U-joint bearings are in need of replacement and that gear is in good
3. If seal is defective, remove U-joint seal using a punch and hammer or press out with suit-
NOTE: The U-joint seal is located in the seal carrier on standard Bravo drives and in the
bearing retainer nut on Bravo X, XZ, XR, and Diesel Bravo.
90-863160 MAY 2000
condition, remove bearings from gear using puller plate and arbor press (bearings are
damaged in removal and should not be reused).
c
a - Gear and Bearing Assembly
b - Puller Plate (91-37241)
c - Spacer
d - Suitable Mandrel
able mandrel.
Standard Bravo Shown
a - Seal
b - Suitable Mandrel
a
d
b
a
DRIVE SHAFT HOUSING
b
22393
22102
Page 3A-31