SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
6. Pull back on bell housing and rotate it 90° to gain access to the trim wire clamp plate
7. Remove trim wire clamp plate.
8. Unplug trim position sender wires from engine harness.
9. Unplug trim limit switch wires from trim pump.
Installation
NOTE: Old harness may be used to pilot new harnesses through hole in gimbal housing.
1. Route new sender wires through hole. Bring together the two grommet halves and
Page 4A-12
screw.
a -
Bell Housing
a
a -
Clamp Plate
b -
Screw
ensure that they are seated lightly in the hole with the flat mating edges vertically
aligned. Maintain light tension on the wires from inside the boat, to hold the grommets
in the hole.
a -
Trim Limit Switch Wires
b -
Trim Position Sender Wires
a
b
b
a
SERVICE MANUAL NUMBER 28
23363
70197
70198
90-863160 MAY 2000