Mercury BRAVO Service Manual page 134

DRIVE SHAFT HOUSING
4. If replacing U-joint cross bearings,proceed as follows:
U-joint snap rings might accidentally be knocked off of the U-joint during installa-
tion. Wear safety glasses to avoid eye injury.
Page 3A-32
a. Drive off universal joint bearing snap rings, using a punch and hammer.
a - Snap Ring
b. Standard Bravo: Using adaptor and U-joint press, press one bearing in until oppo-
site bearing is pressed out into adaptor. Remove loose bearing.
a - Press
b - Adaptor (91-38756)
c - Yoke
c. Turn U-joint assembly 180 degrees and press on bearing cross to remove second
bearing. Remove second bearing. Remove each pair of bearings in this manner.
a - Bearing Cross
b - Adaptor
WARNING
a
c
a
SERVICE MANUAL NUMBER 28
a
b
b
90-863160 MAY 2000
22179
22180
22180