SERVICE MANUAL NUMBER 28
Bearing Cup Removal
1. Remove bearing cup and shims using slide hammer puller. Measure shims for reas-
NOTE: When pulling bearing cup with puller, shims will be damaged. DO NOT reuse shims.
Bearing Cup Installation
1. Install front driven gear bearing cup and original thickness shims using bearing cup driv-
90-863160 MAY 2000
sembly reference.
c
b
a -
Slide Hammer Puller (P/N 91-34569A1)
b -
Bearing Cup
c -
Shims
er and driver rod. If shims were lost or damaged where original thickness cannot be de-
termined, install a .015 in. (0.38 mm) shim for a starting point. Ensure cup is not canted.
Coat cup outer diameter with Quicksilver High Performance Gear Lube.
a -
Shim(s)
b -
Bearing Cup
c -
Driver (P/N 91-805454)
d -
Old Propeller Shaft or Driver Rod
a
d
c
a
b
BRAVO THREE GEAR HOUSING
19808
75958
Page 3D-25