Mercury BRAVO Service Manual page 139

SERVICE MANUAL NUMBER 28
2. Install three new O-rings on coupling end of U-joint shaft.
3. Coat outside diameter of oil seal with Loctite 271 and press oil seal in with lip of seal
NOTE: The U-joint seal is located in the seal carrier on standard Bravo drives and in the
bearing retainer nut on Bravo X, XZ, XR, and Diesel Bravo.
4. Lubricate lip of oil seal (a) with 2-4-C Marine Lubricant with Teflon.
90-863160 MAY 2000
b
a - O-ring Grooves
b - O-rings
facing pinion gear, using bearing driver until tool bottoms out against carrier.
a
b
Standard Bravo Shown
a - Oil Seal
b - Oil Seal Carrier
c - Bearing Driver (91-813653T)
a - Oil Seal Lip
a
c
22103
DRIVE SHAFT HOUSING
c
b
a
73922
22103
22435
Page 3A-37