Drive Shaft Housing And Top Cover - Bearings And Bearing Sleeves Inspection; Bearing Sleeve Removal (Top Cover) - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28
Drive Shaft Housing and Top Cover - Bearings and Bearing
Sleeves
Inspection
1. Inspect needle bearing races in top cover and in drive shaft housing for pitting, grooves,
2. Condition of the bearing surfaces on the clutch shaft are an indication of the condition

Bearing Sleeve Removal (Top Cover)

1. Place puller jaws around sleeve.
2. Position puller guide over jaws and install bolt.
90-863160 MAY 2000
discoloration or embedded particles. If any of these conditions exist, replace race.
of the bearings in the top cover and drive shaft housing. Inspect bearing surface for pit-
ting, grooves, discoloration or embedded particles. If any of these conditions exist, then
replace bearings and shaft.
c
a - Top Cover
b - Puller Jaws (2 Halves) – (91-90244A1)
c - Bearing
a - Puller Guide (91-90244A1)
b - Puller Bolt (90-90244A1)
c - Top Cover
d - Washers
b
b
d
a
DRIVE SHAFT HOUSING
a
c
22083
22084
Page 3A-47