Power Package Recommissioning - Mercury BRAVO Service Manual

MAINTENANCE
9. After paint has dried, spray entire sterndrive with Quicksilver Corrosion Guard. Refer to
Store sterndrive unit in the full trim DOWN/IN position. U-joint bellows may develop
a "set" if unit is stored in raised position and may fail when unit is returned to ser-
vice.
10. If not already done, place sterndrive unit in the full trim DOWN/IN position.
11. Store battery. Refer to battery manufacturer's instructions.

Power Package Recommissioning

Engine
Refer to appropriate Engine Service Manual.
Sterndrive
1. Perform ALL maintenance specified for completion "Annually" in "Maintenance Chart"
2. Install fully-charged battery.
3. Clean battery cable clamps and terminals.
4. Reconnect battery cables. Be sure to tighten clamps securely.
5. Apply a thin coat of petroleum based grease to clamps and terminals to help retard
6. After recommissioning and starting engine, check steering system and shift control for
Page 1B-14
SECTION 1B.
except items which were performed at the time of sterndrive layup.
corrosion.
proper operation.
CAUTION
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000