Installing Electrode Assembly - Mercury BRAVO Service Manual

CORROSION PROTECTION - ALL MODELS

Installing Electrode Assembly

O-ring MUST BE properly seated in groove of electrode assembly or water leakage
into boat will result.
1. Electrodes have a factory installed rubber grommet and Do NOT require an O-ring.
2. Form a 2 ft. (610 mm) long piece of .032 in. (6.8 mm) diameter wire to the dimensions
3. Insert 45_ angle end of wire through center hole in hydraulic connector block.
Page 7A-10
a - Electrode
b - Rubber Grommet
shown.
c
a - 2 Ft. (610 Mm) Of Approximately .032 In. (0.8 Mm) Dia. Wire
b - 5 in. (123 mm)
c - 45_ Angle
d - 1/2 in. (13 mm)
CAUTION
a
b
d
SERVICE MANUAL NUMBER 28
b
a
90-863160 MAY 2000
71862
74106