Bearing Sleeve Installation - Mercury BRAVO Service Manual

SERVICE MANUAL NUMBER 28

Bearing Sleeve Installation

1. Install driver head onto puller guide. Secure driver head to puller guide with screw. Place
2. Place driver guide onto top cover as shown. Install puller guide assembly through driver
3. Place driver guide into top of drive shaft housing, as shown. Install puller guide assembly
90-863160 MAY 2000
bearing sleeve against edge of driver head as shown.
a - Driver Head (91-862530)
b - Puller Guide (91-90774)
c - Screw (91-90775)
d - Bearing Sleeve
guide assembly and install bearing sleeve by tapping into place until tool bottoms out.
a - Driver Guide (91-90244A1)
through driver guide and install bearing sleeve by tapping into place until tool bottoms out.
a - Driver Guide (91-90244)
c
b
a
DRIVE SHAFT HOUSING
a
d
a
22084
22082
22263
Page 3A-53