OILDYNE TRIM PUMP
Maintaining Power Trim Pump Oil Level
Avoid pump damage. Vent reservoir pressure by backing out the vent screw two
turns after tightening completely. Units without a vent screw have a vented fill cap.
Remove the fill neck seal on models without a vent screw.
IMPORTANT: Check the oil level with the sterndrive unit in the full down position.
IMPORTANT: If quicksilver Power Trim and steering fluid is not available, SAE 10W-30
or 10W-40 engine oil can be used in the system.
1. Raise and lower the sterndrive unit 6 to 10 times to purge air from the system. Check
2. Maintain the oil level between the "Max" and "Min" marks on the side of the reservoir.
Page 5A-4
the oil level visually.
Fill to the bottom lip on the fill neck.
a -
Bottom Lip On The Fill Neck
b -
Vented Cap
CAUTION
a
SERVICE MANUAL NUMBER 28
b
22031
90-863160 MAY 2000